How to stop a waistband from rolling over or buckling.
Have you ever had a problem with trousers that buckle, crumple or roll over at the waistband? Even though they seem to fit nicely at your waist or hips and are comfortable, by the end of a day of wear the perfectly pressed waistband is a squished mess. This 'roll-over' can be caused by the difficult to fit proportions of a rounded tummy but this isn't always the case - some people find it is amplified by the size of their belt loops or the width of their belt. They notice that some pants buckle all of the time and other pairs do not. They find that pants that fit higher on their waist are less likely to buckle than low rise options (or vice versa). It can be a tricky problem to deal with! One easy solution I have found is the use of Ban Rol instead of a regular fusible interfacing. Ban Rol is a stiff polyester trim that you can insert between the waistband and waistband facing during the construction of the trousers or skirt. It's really easy to use and creates a gorgeous stiff waistband! Aside from preventing waistband crumpling, it also keeps the corners of your waistband at a perfect right angle. I've carried Ban Rol in our shop for quite some time now (for $1.20 CAD per metre) but I haven't really explained its use on the blog or created a tutorial! I'm in the midst of making all new samples for our Thread Theory patterns and so thought I would take the opportunity to photograph how I insert Ban Rol into the waistband of the Jedediah Pants. It's really easy! My method does not involve stitching the stabiliser to the waistband at all - it is simply floating freely within the waistband casing. This is a quick method that I find works just as nicely as other methods I have seen...as long as your Ban Rol matches the finished width of your waistband. You can trim Ban Rol so that it is narrower to match a thin waistband but I wouldn't recommend using Ban Rol that is too narrow for an extra wide waistband. We carry the correct size for the Jedediah Pants or Jutland Pants patterns (1 1/2" wide). It is also a pretty standard size for most trouser and jean waistbands. Cut the Ban Rol to approximately the length of the waistband. I just cut it the length of the pattern piece and trimmed off the seam allowances later. Sew your waistband as per normal. Various pattern instructions will include different waistband construction techniques. Regardless of the technique used, stop construction when there is still an opening into which you can insert the Ban Rol. In the case of the Jedediah Pants, this is after you have sewn the waistband to the pants and created the corners (Belt Loops & Waistband Step 9). Gently push the Ban Rol behind the seam allowance and, if necessary, use a point turner or tweezers to push it right into one finished corner of the waistband. Here, looking at the wrong side of the pants, you can see that the Ban Rol is tucked underneath the seam allowances: Before pushing it into the other end of the waistband, place a pin through the first corner so that you do not pull the Ban Roll out of place. Also, make sure that the Ban Rol is the perfect length. If it is too long, just trim the Ban Rol slightly. Now close up the waistband as per the pattern instructions so that your Banrol is encased but still sitting freely within the waistband (you don't need to stitch through it at all). Here's how your waistband will look from the right side (sans a jeans button): And from the wrong side (I love my buffalo check binding!): Enjoy washing and wearing your perfectly crisp waistband...crumple and roll-free!